771
DP-C405/C305/C265
FEB 2008Ver. 1.1
b. Job Offset
The Machine pulls the sheet once to the Processing Tray. It then moves the sheet to the front, or the
rear using the Aligning Plate. When it has deposited a specific number of sheets, it delivers them in
the form of an aligning plane. When the number of sheets stacked on the Processing Tray reaches
a specified value, the sheets are delivered in a form of a stack. Even if the specified value is not
reached, stacked sheets are temporarily delivered when 10 sheets of large-size paper (300 mm or
longer), or 30 sheets of small-size paper (299 mm or shorter) have been stacked. (5- and STMT-
sizes: 10 sheets)
Fig. 2-012
Results of offset delivery (4 jobs)
(Delivery Direction)
3rd set
1st set
4th set
2nd set
To Next Page
Loading...
