Panasonic DP-C305 - Jam Sensor Location of Printer

449
DP-C405/C305/C265
FEB 2008Ver. 1.1
Note:
If the machine is jammed, follow the procedure below.
1. Turn the Power Switch on the Left Side, and the Main Power Switch on the Back of the machine to
the OFF position. (If the Hard Disk Drive Unit is installed, turn the Power Switch on the Left Side of
the machine to the OFF position first. After waiting approximately 10 seconds, turn the Main Power
Switch on the Back of the machine to the OFF position.)
2. Remove the Jammed paper.
3. Turn the Main Power Switch on the Back, and the Power Switch on the Left Side of the machine to
the ON position.
4. Press the “Function”, and the “3” keys on the Control Panel.
• Jam Sensor Location of Printer
Paper Path Sensor (Tray 4) (1919)
Paper Path Sensor (Tray 3) (1919)
Paper Path Sensor (Tray 2) (1919)
Paper Tray 4
Paper Tray 3
Paper Tray 2
Paper Tray 1
Sheet Bypass
Paper Path Sensor (Tray 1) (1919)
OHP Film Sensor (2110 : ROHP PCB)
Optional Intermediate Roller Sensor (2130)
Registration Sensor 1 (2110 : ROHP PCB)
Registration Sensor 2 (1918-01)
Fuser Entrance Sensor (1819-43)
Inner Exit Sensor (1819-39)
Outer Exit Sensor (1819-20)
Optional Intermediate Roller
Jam Sensor (1819-03)
Intermediate Roller Jam
Sensor (1819-01)
Paper Path Sensor (ADU 0)
(1819-38)
Paper Path Sensor
(ADU 1) (1819-31)
Paper Path Sensor
(ADU 2) (1819-07)
Sheet Bypass
NP Sensor (1819-37)
Fuser Paper Exit Sensor (1819-32)
ADU
Intermediate Transfer Belt
Paper Path Sensor
(Paper Transport Unit) (1819-21)