167
DP-C405/C305/C265
FEB 2008Ver. 1.1
(36) Remove 12 Screws (X5).
(37) Remove 2 HVPS1 PC Boards (4014).
(A) : For Yellow / Magenta
(B) : For Cyan / Black
(38) Remove 4 Screw (X5).
(39) Pull the HVPS2 PCB Bracket (4003) out.
<Removing the Motor Assemblies>
(40) Open the Front Cover.
(41) Remove the Toner Waste Container.
(42) Turn the Levers counterclockwise.
(43) Pull the Drum Units out approximately 20mm.
Note:
When pulling out the Drum Unit, exercise care not
to expose the Drum to light.
(44) Remove 6 Motor Assemblies according to the
following steps.
Note:
The Motor Assemblies are keyed for their
respective locations; do not force them into an
incorrect position as damage to the Motor
Assembly, or machine may occur.
To Next Page
Loading...
