621
DP-C405/C305/C265
FEB 2008Ver. 1.1
7.4. Setting
7.4.1. Set the Date and the Time
1. Press the “Function” key on the Control Panel.
2. Select “General Settings” on the Touch Panel display.
3. Scroll the menu with the “” button on the Touch Panel display, and select “09 Key Operator
Mode”.
4. Enter the 8 character Code (default is 00000000), and then select the “OK” button.
5. Scroll the menu with the “” button on the Touch Panel display, and select “22 Date Time Setting”.
6. Select “Input”, and then enter the Date and the Time.
7. Select the “OK” button on the Touch Panel display.
8. Select the “Close” button on the Touch Panel display.
9. Press the “Reset” key on the Control Panel, to exit the General Settings mode.
7.4.2. Set the Customer’s Information
Register the required information when entering the Service Mode for the first time after the installation of
the machine by following the steps below. If registration is not completed, the registration screen is
displayed each time when entering the Service Mode.
1. Press the “Function”, “Copy”, and the “3” keys simultaneously on the Control Panel.
2. Input the password, and select the “OK” button to enter the Service Mode (default password is
00000000).
3. Select the “Yes” button to Register the Installation Date.
4. Select a business category, and then select the “OK” button on the Touch Panel display.
The LCD displays 5 Business Categories on the screen, and there are 5 screens in total.
To Next Page
Loading...
