150
DP-C405/C305/C265
FEB 2008Ver. 1.1
(30) Gently peel the Tape off in the direction of the
arrow.
(31) Remove 2 Screws (X8).
(32) Remove the Developer Cover (5401) by
releasing 4 latches.
<Replacing the Developer>
Note:
Only if a problem occurs, perform the step below.
If there is no problem, skip to the step (34).
(33) Turn the Developer Unit upside down over a
suitable waste container or a sheet of paper, and
dump the used Developer and Toner by rotating
the gear counterclockwise.
<Pouring the Developer>
Caution:
1. Place the Developer Unit Horizontally as
illustrated, and then carefully pour the developer.
2. If it is placed on a slope or is slanted, the
developer will not pour evenly causing the Cover
to bulge when closed, or the developer may spill.
Then the Cover of the developer touches the
Intermediate Transfer Belt, causing abnormal
White Blank Vertical Lines on the printed image.
To Next Page
Loading...
