Panasonic DP-C305 - F5 Mode: Function Parameters (for Copier)

511
DP-C405/C305/C265
FEB 2008Ver. 1.1
5.1.5. F5 Mode: Function Parameters (For Copier)
Set the machine to Service Mode, and press the “5” key on the Control Panel.
↓
Press the “Start” key to enter the F5 Service Mode on the Control Panel.
↓
Select the desired code number on the Touch Panel display.
↓
If you wish to select another function, select the Tab key on the Touch Panel display, or scroll the menu
with the “”, “” buttons.
↓
Select the desired function on the Touch Panel display, and then select the “OK” button.
When the “Cancel” button is selected, the selected code input will not be accepted.
↓
Select the “Close” button on the Touch Panel display.
↓
Press the “Function”, and the “C (Clear)” keys simultaneously on the Control Panel to exit the Service
Mode.
↓
Reboot the machine after setting the parameter(s) to activate the setting(s). (Turn the Power Switch on
the Left Side of the machine to the OFF then back to the ON position.)
F5 Mode
No. Item Selection Default Setting Remarks
00 Country Version Japan
USA/CAN
Europe
Other
Country
Dependent
Check the destination of the
Firmware. (Read Only)
01-03 Not Used
04 LSU Off Timer 5 sec.
10 sec.
15 sec.
20 sec.
30 sec.
40 sec.
50 sec.
60 sec.
15 sec. Set the Polygon Motor rotation
time period after completing the
print job.
If the set time period is longer than
the recommended 15 sec., the
interval period between printing
operation is shorter, and the
increase in spinning time may
shorten the motor's useful life
cycle.
05 LSU Fan Extension None
2 min.
5 min.
None Prevent temperature from rising
inside of the unit by extending the
LSU Fan timer in a heavy usage
environment.
06 Job Tracking Server No
Yes
No Activate the Job Tracking Server.
It works with the Communication
Job Search function of the
Panasonic Network Accounting
Manager.