634
DP-C405/C305/C265
FEB 2008Ver. 1.1
(10) Loosen 11 Screws.
(11) Remove the Rear Cover.
(12) Connect the SCN Harness to connectors
CN702, and CN709 on the SCN PC Board.
(13) Route the Harnesses through the access slot on
the machine as illustrated.
(14) Connect the SCN Harness to the pre-installed
Harness.
(15) Connect the SCN Harness to CN51 on the SC
PC Board.
(16) Connect the USB Cable to CN65 on the SC PC
Board.
Caution:
Connect the USB Cable to the upper USB port
connector on the SC PC Board.
(17) Secure the SCN Harness, and USB Cable with 1
Harness Clamp.
To Next Page
Loading...
