Panasonic DP-C305 - Removing the Finisher Controller PCB; Removing the Slide Home Position PCB

831
DP-C405/C305/C265
FEB 2008Ver. 1.1
12.1.3.1.3. PCBs
Fig. 3-072
3-1. Removing the Finisher Controller PCB
(1) Remove the Rear Cover. (See Removing the
Rear Cover)
(2) Disconnect 17 Connectors [1], and remove 1
Screw [2].
(3) Free the PCB Retainer [3], and detach the
Finisher Controller PCB [4].
Fig. 3-073
3-2. Removing the Slide Home Position PCB
(1) Open the Front Door [1], and turn the Tab [2] on
the stapler slide in the direction of the arrow to
slide the Stapler to the front most point.
(2) Remove the Stapler Unit. (See Removing the
Stapler Unit)
Fig. 3-074
(3) Place the Stapler Unit [3] as shown.
(4) Remove 2 Screws [4], and detach the Guide [5].
[2]
[1]
[1]
[1]
[3]
[4]
[1]
[2]
[4]
[4]
[3]
[5]