Panasonic DP-C305 - Removing the Motor Drive Unit

248
FEB 2008Ver. 1.1
DP-C405/C305/C265
(17) Remove all the Harnesses from HVPS2 PC
Board, and Bracket.
(18) Remove 4 Screws (X5).
(19) Pull the HVPS2 PCB Assembly out.
(20) Remove 3 Screws (X5).
(21) Pull the HVPS1 PC Board Assembly out.
<Removing the Motor Drive Unit>
(1) Open the Front Cover.
(2) Remove the Toner Waste Container.
(3) Turn the Levers counterclockwise.
(4) Pull all the Drum Units out by approximately
20mm (0.79 in).
Note:
When pulling the Drum Unit out, exercise care not
to expose the Drum.
(5) Remove 2 Screws (X5).
(6) Remove the SC Support Bracket (3903).