Panasonic DP-C305 - Error Messages on Remote Entry Failure; Error Messages Generated During Remote Entry

747
DP-C405/C305/C265
FEB 2008Ver. 1.1
10.2. Error Messages Generated during Remote Entry
If errors occur during remote entry in the address book or program dialing, error messages are Emailed
from this machine to the sending station.
10.2.1. Error Messages
If errors occur during remote entry in the address book or program dialing, the following error messages are
Emailed from this machine to the sending station:
10.2.2. Error Messages on Remote Entry Failure
If errors occur during remote entry in the address book or program dialing, the following error messages are
Emailed from this machine to the sending station:
No. Error message Probable cause and recommended action
1 554 Data transfer error (broken header) Process was aborted due to an error occurring while encoding 
the header or sub-header. Resend.
2 554 Data transfer error (broken data) Process was aborted due to an error occurring while encoding 
data. Resend.
3 554 Data transfer error (Fax module) A data transfer error occurred on the Fax module while
communicating with the LAN module. Resend.
4 554 MIME attachment not supported
(message/file)
An unsupported MIME file attachment was transmitted. Resend
the document with text data alone.
5 554 MIME format not supported An unsupported MIME type was transmitted. Resend the 
document with text data alone.
6 554 Fax relay permission denied The name of the domain requesting relay is not preprogrammed.
7 554 Relay address unknown The telephone number of the final receiving station requesting
relay is unknown.
8 554 Memory fully (Fax module) Fax memory is full. Resend later.
9 554 Data transfer error This error is not on the list. Resend later.
No. Error message Probable cause and recommended action
1 There is an error in the @command block. The block end command "@end" is missing in the "@command "
block. Resend with the addition of an "@end " command.
2 The @begin command is missing. The block start command "@begin" is missing in the "@begin"
block. Resend with the addition of an "@begin" command.
3 There is an error in the @begin block. The block end command "@end" is missing in the "@begin" block.
Resend with the addition of an "@end " command.
4 There is an error in the @system block. The block end command "@end" is missing in the "@system "
block.
Resend with the addition of an "@end " command.
5 There is an error in the @sender block. The block end command "@end" is missing in the "@sender "
block.
Resend with the addition of an "@end " command.
6 There is an error in the @domain block. The block end command "@end" is missing in the "@domain"
block. Resend with the addition of an "@end " command.