Panasonic DP-C305 - Removing the Punch Controller PCB; Removing the Photo Sensor PCB

836
DP-C405/C305/C265
FEB 2008Ver. 1.1
12.1.3.2.2. PCBs
Fig. 3-085
2-1. Removing the Punch Controller PCB
(1) Remove 2 Screws [1].
(2) Disconnect 5 Connectors [2] to remove the
Punch Controller PCB [3].
Fig. 3-086
2-2. Removing the Photo Sensor PCB
(1) Remove the Punch Motor. (See Removing the
Punch Motor)
(2) Remove 1 Screw [1].
(3) Remove the Harness [3] from the Harness
Guide [2] on the PCB, then detach the PCB
Cover [4].
[2]
[2]
[2]
[1]
[3]
[1]
[3]
[2]
[4]