Panasonic DP-C305 - Page 447

447
DP-C405/C305/C265
FEB 2008Ver. 1.1
U7 Close Right Cover Lower
(Feed Cover2/Feed Cover(Option))
1. Right Cover is open.
2. Right Cover Sensor is disconnected.
3. Right Cover Sensor is defective.
4. LVPS connector is disconnected.
5. LVPS is defective.
6. EC PCB connector is disconnected.
7. EC PCB is defective.
U8 Close Paper Transport Unit 1. Paper Transport Unit open.
2. Paper Transport Unit Sensor disconnected.
3. LVPS connector disconnected.
4. LVPS defective.
5. EC PCB connector disconnected.
6. EC PCB defective.
U11 Remove Paper in Finisher 1. Paper left in the Finisher.
2. Finisher Paper Exit Sensor defective.
U12 Close Finisher Staple Cover / Upper
Cover
No Punch Dust Box
1. Close Finisher Staple Cover.
2. Finisher Staple Cover Sensor is disconnected.
3. Finisher Staple Cover Sensor is defective.
4. Punch Dust Box is not installed (DA-FS405/FS356/
FS325 only).
U13-1 No Toner or Low Toner (Y) 1. Toner Cartridge is not installed correctly.
2. No or Low Toner.
3. EC PCB connector is disconnected.
4. EC PCB is defective.
5. Hopper Unit is not installed correctly.
U13-2 No Toner or Low Toner (M)
U13-3 No Toner or Low Toner (C)
U13-4 No Toner or Low Toner (BK)
U14 Replace Toner Waste Container 1. Toner Waste Container is full.
(See Section 9.18.)
U15 No Toner Waste Container 1. Toner Waste Container is not installed.
2. Toner Waste Container Sensor is disconnected.
3. Toner Waste Container Sensor is defective.
U16 No Developer Unit
(Y, M, C, BK)
1. Developer Unit is not installed.
U18 Total Copy Limit Over 1. Department Copy Counter is full.
U20 Close ADF Cover 1. ADF Cover is open.
2. ADF is not installed correctly.
3. ADF Cover Sensor is disconnected.
4. ADF Cover Sensor is defective.
5. LVPS connector is disconnected.
6. LVPS is defective.
U21 Close ADF 1. ADF and ADF Cover are open.
2. ADF Sensor is disconnected.
3. ADF Sensor is defective.
U25 Toner Cartridge Motor Rotation Error
(Y, M, C, BK)
1. Toner blocked in the Toner Cartridge.
(Shake the Toner Cartridge to loosen the contents)
U27 No Fuser Unit 1. Fuser Unit is not installed.
U28 No Drum Unit
(Y, M, C, BK)
1. Drum Unit is not installed.
U29 Replace Drum Unit
(Y, M, C, BK)
1. Drum Unit requires replacement.
U30 Close Punch Cover
(Upper/Front Cover)
1. Punch Cover is open.
2. Punch Cover Sensor is disconnected.
3. Punch Cover Sensor is defective.
User Error Codes (U Code) Table
Code Item Check Points