694
DP-C405/C305/C265
FEB 2008Ver. 1.1
(11) Turn the Adjusters to adjust the height, or the
perpendicular position of the Finisher to the
machine. (Gaps “A” and “B” should be
identical).
Note:
If the Finisher is not latched properly, loosen 2
Screws, and adjust the height using the adjusters.
(12) Proceed with the installation of other options. If
finished, reinstall all Harnesses, and Covers.
(13) Plug the AC Power Cord into the wall outlet, and
turn the Main Power Switch on the Back, and the
Power Switch on the Left Side of the machine to
the ON position.
(14) Reconnect the Telephone Line / LAN Cable if
disconnected.
To Next Page
Loading...
