85
DP-C405/C305/C265
FEB 2008Ver. 1.1
(7) Unhook 2 Pressure Springs (5006).
Caution:
Don't use a plier for unlocking the Springs, Not to
damage the spring. Ensure the Pressure Springs
are unlock position when replace the Fuser Belt
Unit.
Caution:
To unlock the Pressure Springs: Press the Energy
Saver , and then turn off the Power Switch on the
Left side of the machine.
<For DP-C405 / C354 Series>
Follow the steps below
<For DP-C322 Series> Skip to step (16)
(8) Disconnect 1 Harnesses.
(9) Remove 3 Black Screws (Y41).
(10) Remove the Shaft Plate (4916).
To Next Page
Loading...
