Panasonic DP-C305 - Page 855

855
DP-C405/C305/C265
FEB 2008Ver. 1.1
4. E7-22, Alignment Plate Motor (Rear) Fault
Table 5-013
5. E7-23, Staple / Fold Motor Fault
Table 5-014
Table 5-015
Table 5-016
Aligning Plate Home Position Sensor (rear; PI5)
1) Check the aligning plate home position sensor (rear). Is the sensor normal?
NO :Replace the sensor.
Wiring
2) Is the wiring between the Finisher Controller PCB and the rear alignment motor
(rear) normal?
NO :Correct the wring.
Aligning Plate (rear)
3) Is there mechanical trapping in the path of the aligning plate?
YES:Correct the mechanical mechanism.
Alignment Motor (rear; M5), Finisher Controller PCB
4) Try replacing the alignment motor (rear). Is the problem corrected?
YES:End.
NO :Replace the Finisher Controller PCB.
Wiring
1) Is the wiring between the Finisher Controller PCB and the Staple/Fold Motor
normal?
NO :Correct the wring.
Stapler Unit
2) Try turning the staple jam releasing dial. Is there mechanical trapping?
YES : Correct the mechanical system.
Staple / Fold Motor (M7), Finisher Controller PCB
3) Try replacing the staple / fold motor. Is the problem corrected?
YES:End.
NO :Replace the Finisher Controller PCB.
Finisher Controller PCB, Stapler Unit
1) Does the stapler / fold motor operate at the appropriate timing?
YES:Replace the Finisher Controller PCB.
NO :Check the stapler unit drive mechanism: if faulty, correct it; if normal.
Staple / Fold Motor (M7), Finisher Controller PCB
2) Try replacing the staple / fold motor. Is the problem corrected?
YES:End.
NO :Replace the Finisher Controller PCB.
Saddle Unit
3) Try turning the fold jam releasing dial. Is there mechanical trapping?
YES:Correct the mechanical mechanism.