Parker AC30 - Ethernet Parameter Summary

Ethernet 12-8
AC30 series Variable Speed Inverters
ETHERNET PARAMETER SUMMARY
Parameter Name
No.
Path
Default
Range
Units
Writable
Ethernet State
0919
Monitor::Communications::Base Ethernet
Parameters::Base Comms:: Ethernet
0:INITIALISING
0:INITIALISING
1:NO LINK
2:RESOLVING IP
3:RESOLVING DHCP
4:RESOLVING AUTO-IP
5:RESOLVED IP
6:STOPPING DHCP
7:DUPLICATE IP
8:FAULT
NEVER
Ethernet parameter.
Provides the state of the inverter Ethernet link.
Enumerated values:
0: INITIALISING - Driver initialising
1 :NO LINK - Ethernet not connected to a network
2: RESOLVING IP - Waiting for an IP address to be set manually
3: RESOLVING DHCP - Waiting for a DHCP server to provide an IP address
4: RESOLVING AUTO-IP - Waiting to Auto-IP to provide an IP address
5: RESOLVED IP - IP address is set – communication is possible
6: STOPPING DHCP - Inverter is stopping the DHCP service
7: DUPLICATE IP - Another device on the network has the same IP address
8: FAULT - Fault detected
MAC Address
0920
Monitor::Communications::Base Ethernet
Parameters::Base Comms:: Ethernet
00-00-00-00-00-00
xx-xx-xx-xx-xx-xx
NEVER
Ethernet parameter.
Provides the Ethernet MAC address.