Installation 4-10
AC30 series Variable Speed Inverter
THROUGH PANEL MOUNTING DETAIL (FRAMES D – J ONLY)
To allow mounting; first disassemble the inverter by following instructions 1 to 4 and then instructions 5 to 7 for mounting:-
1. Unscrew and remove mounting bracket(s).
2. Remove Control Module Cover (see page 4-18).
3. Remove Control Module (see page 4-19).
COVER REMOVAL INSTRUCTIONS – ALL FRAMES
4. Top & Bottom Cover Removal Instructions
Frame D
Top Cover: Squeeze together the bracket under the top cover and lift off cover.
Bottom Cover: After inserting a screwdriver into the slot slightly push to the left
to release the catch.
To Next Page
Loading...
