Parker AC30 - Control Module Removal

4-19 Installation
AC30 series Variable Speed Inverter
Control Module Removal
WARNING Isolate supply before plugging or unplugging control unit to the power stack.
1. Unscrew captive screw.
2. Lift lower edge of assembly.
4. Lift assembly away from Power Stack
3. Slide assembly
upwards, as far as
possible, to unlatch
from unit.
Note that there are two
screws used to retain the
AC30D control module. The
communications option, if
fitted, should be temporarily
removed to access one of the
two screws.