Parker AC30 - Device Commands

Parameter Reference D-45
AC30 series Variable Speed Drive
Device Commands
Parameters::Device Manager::Device Commands
Parameter Name
No.
Path
Default
Range
Units
Writable
Update Firmware
1002
Parameters::Device Manager::Device
Commands
FALSE
STOPPED
This parameter is only visible when an SD card with a firmware update file is inserted into the drive. Changing this parameter to TRUE
will start the firmware update procedure.
Following a firmware update it is advisable to power re-run the Setup Wizard, D-153
Save All Parameters
1001
Parameters::Device Manager::Device
Commands
FALSE
ALWAYS
When a parameter is modified via the GKP or via the built-in web page the parameter value is saved automatically. When a parameter
is modified via another source, (for example via the Modbus TCP/IP communications protocol), the value will not be saved
automatically. In this case a save may be instigated by changing this parameter from FALSE to TRUE.