Parker AC30 - DC FED Power Wiring Connections (Frames D - J Only)

4-17 Installation
AC30 series Variable Speed Inverter
DC FED POWER WIRING CONNECTIONS (FRAMES D – J ONLY)
Feed the power supply and motor cables into the inverter under the cable clamps using the correct cable entries, and connect to the
power terminals. Tighten all terminals to the correct tightening torque; refer to the Terminal Tightening Torques table (page 4-39).
AC Motor
Chokes.
Only on long
cable runs >50m
Earth
Earth
Earth
Stud
Cable Clamps
Earth stud
Motor Terminals