Parker AC30 - Page 33

Installation 4-12
AC30 series Variable Speed Inverter
5. Fit gasket to the inverter so that an air-tight seal
will be made between the inverter and the
panel.
Through Panel Kits, can be purchased from
Parker using the following part numbers:
Frame D – LA502668
Frame E – LA502669
Frame F – LA502670
Frame G – LA502471
Frame H – LA502472
Frame J – LA502793
Frame K – not applicable
6. Tighten all screws in place as shown, according
to panel insert requirements.
7.
At this stage you can wire the power cables, see
page 4-16.
Upper Terminal
Cover
Cover Front
Upper
GKP
Control Unit Terminal Cover
(Cover Front Lower)
Lower Terminal
Cover
Snap out to allow entry to the
braking terminals
Gasket