D-192 Parameter Reference
AC30 series Variable Speed Drive
A 32-bit word that indicates trip sources that are close to a fault condition. Bit 0 of this word corresponds to trip 33, up to bit 31 of this
word which corresponds to trip 64.
The Warnings value is not affected by the corresponding trip enable mask, “Enabled 33-64”.
Refer to Chapter 10 “Trips and Fault Finding” for details of the value corresponding to each trip.
Parameters::Trips::Trips Status
When this parameter is TRUE, warnings are reported on the GKP as a message that hides any parameter display, (until the message
is manuall acknowledged). Set this parameter to FALSE to prevent warning messages being shown on the GKP.
To Next Page
Loading...
