128
Control
Display Description
ERROR: 214 No carriage start NIS
ERROR: 215 Ramp not completed
ERROR: 216 Material does not reach the clamp
ERROR: 217 Needle thread malfunction
ERROR: 241
(#Sewing motor error)
Sewing motor error,
see chapter 14.02.04 Sewing motor errors
ERROR: 242 Remove material
ERROR: 281 Remove material, material not in clamp
ERROR: 282 Stacker full
ERROR: 283 Needle thread malfunction
ERROR: 284 Bobbin thread malfunction
ERROR: 301 Program too large
ERROR: 302 Contradiction between progpar and progload
ERROR: 303 Flash read error or faulty program
ERROR: 304 Memory overrun
ERROR: 305 Invalid configuration
ERROR: 306 Needle zero point invalid
ERROR: 310 File not on source
ERROR: 311 Source read error, file cannot be opened
ERROR: 312 Target write error, file cannot be opened
ERROR: 313 Source read error
ERROR: 314 Target write error
ERROR: 315 File config. cannot be opened
ERROR: 316 Error when opening MDAT-file
ERROR: 317 Write error in MDAT-file
ERROR: 318 Machine data identification incorrect
ERROR: 319 Read error in MDAT-file
ERROR: 320 Program with incorrect machine class
ERROR: 321 Program with incorrect machine variant
ERROR: 322 Program with incorrect data set version
ERROR: 323 Incorrect program number
ERROR: 324 No carriage start, NIS
ERROR: 330
(#Stitch generation error)
(#Program number)
Stitch generation error,
see chapter 14.02.03 Stitch generation errors
ERROR: 341
(#Sewing motor error)
Sewing motor error,
see chapter 14.02.04 Sewing motor errors
PROGRAM XX NOT IN
MEMORY
Program XX does not exist
To Next Page
Loading...
