Adjustment
13 - 1
13 Adjustment
Before beginning any adjustment work, take note of the safety regulations
found in chapter 1 Safety of this instruction manual!
13.01 Notes on adjustments
All adjustments in these adjustment instructions are based on a completely assembled
machine and must only be carried out by appropriately trained specialists. Covers on the
machine which have to be removed for checks and adjustment work and later remounted
are not mentioned. The parts in () are for securing machine parts and must be loosened
before the adjustment and retightened after all adjustments are carried out.
13.02 Tools, gauges and other accessories
● 1 set of screwdrivers with blade widths from 2 to 10 mm
● 1 set of wrenches with jaw widths from 6 to 22 mm
● 1 set of Allan keys from 1.5 to 6 mm
● 1 universal screwdriver with interchangeable blades
● 1 metal ruler
● 1 adjustment pin (zero point adjustment)
● 1 adjustment gauge (for sewing head adjustments)
● 1 adjustment gauge (for adjustments to feed)
● 1 needle rise gauge, part no. 61-111 600-01
● 1 adjustable clamp, part no. 08-880 137 00
● Sewing thread and test material
● Needles
13.03 Abbreviations
TDC = top dead center
BDC = bottom dead center
To Next Page
Loading...
