Pfaff 3588-04/020 - Summary of the Functions in the Initial State (Entering Seam Programs)

Input mode functions
11 - 22
11.06.03 Summary of the functions in the initial state (entering seam programs)
The function CREATE / MODIFY PROGRAM is only accessible when the
machine is in its basic position. If required, a code number must be entered, a
sewing pattern inserted and a program number must be selected.
Input menu
2 - CREATE / MODIFY PROGRAM
INPUT mode
Presser foot up/down
Step-by-step backwards
Step-by-step forwards
Block functions
1 - MARK START OF BLOCK
2 - MARK END OF BLOCK
3 - MANIPULATE BLOCK
1 - SCALE UP FACTOR FOR X-AXIS
2 - SCALE UP FACTOR FOR Y-AXIS
3 - ROTATION ANGLE
4 - MIRROR
4 - MOVE BLOCK
5 - DELETE BLOCK
Pattern functions
1 - MOVE PATTERN
2 - MANIPULATE PATTERN
(SYMMETRY POINT WITH TRANSFER KEYS)
1 - SCALE UP FACTOR FOR X-AXIS
2 - SCALE UP FACTOR FOR Y-AXIS
3 - ROTATION ANGLE
4 - MIRROR
3 - MANIPULATE PATTERN
(SYMMETRY POINT WITH NUMERIC KEYS)
1 - SCALE UP FACTOR FOR X-AXIS
2 - SCALE UP FACTOR FOR Y-AXIS
3 - ROTATION ANGLE
4 - MIRROR
Change
Delete
Reference point for coordinates
Activate Insert (see chapter 11.06.05)