8 - 4
Mounting and commissioning the machine
8.05 Turning the machine on/off
● Check air pressure on the manometer 1.
If necessary, adjust the air pressure on
adjusting knob 2.
● Turn On/Off switch 3 to position "I".
After the machine has been
switched on, it is always in the
automatic sewing mode.
When commissioning the
machine, the zero point must
be checked and, if necessary,
adjusted (see chapter 8.07
Adjusting zero point).
● To switch off the machine, turn the
On/Off switch 3 to position " 0 ".
8.06 Connecting a disk drive
● If you are using a disk drive for entering
seam programs and/or machine data,
insert the plug of the transmission cable
into socket 1.
● The disk drive’s mains plug can be
connected to socket 2.
Fig. 8 - 05
Fig. 8 - 06
1
1
2
3
2
To Next Page
Loading...
