Adjustment
13 - 29
13.05.26 Synchronizer
Requirement
After the sewing operation has been completed, the machine is to position at TDC of the
take-up lever.
Fig. 13 - 27
● Allow sewing machine to carry out positioning (switch on/off).
● Loosen screws 1.
● Hold synchronizer 2 firmly and bring take-up lever 3 to TDC by turning the handwheel 4.
● Tighten screws 1.
After positioning is completed and the presser foot is raised, the needle must
not extend underneath the presser foot.
1
2
3
4
To Next Page
Loading...
