14 - 20
Controller
14.03.02 Table of machine data (MDAT)
The following input functions are stored:
program station A
program station B
parts program number
automatic program change
Bobbin thread functions: bobbin thread pre-select
Head functions: maximum speed
reduced speed
delay zigzag on
delay zigzag off
sewing
Folder functions: intermediate stop
uni-material
basic position pocket plate
alternating folding
alternating labelling
Edge folder configuration
Parts program functions: rolling direction stacker
(all 20 parts programs) slow rolling time stacker
fast rolling time stacker
Time for stack trestle back
time for edge folders back
time for pocket plate up
feed speed
seam correction X
seam correction Y
Counter: surpressed stitches needle thread monitor
surpressed stitches bobbin thread monitor
stitch reversal
Response time, needle-thread monitor
slow start-stitches
carriage start (NIS)
start for thread trimming
Switch functions: needle thread monitor
bobbin thread monitor
bobbin thread sensor
language selection
tilt head (bedplate)
jig monitor
folder version
label feed
Jig version
flap
continuous carriage movement
lock/release functions
Times: Time for label clamp closed
Service: cutting speed pre-select
code number
To Next Page
Loading...
