9 - 11
Preparation
9.10 Changing the part set
The seam program, parts program and parts (folding set, pocket plates and
sewing jig) must match and always be used together!
If the wrong combination of parts and seam program is used, the machine may
be damaged seriously!
● Select INPUT mode.
● Select Folder position function (number key 8).
● Select PART SET function.
● Loosen screws 1
and 2, and remove both sewing jig 3 and pocket plate 4.
● Insert a new pocket plate and a matching sewing jig.
● Tighten screws 1
and 2.
● Confirm the new pocket plate and sewing jig by pressing the plus key.
● Unscrew the compressed air supply 5.
● Loosen screw 6 and remove folder set 7.
● Insert the folder set which matches the pocket plate and the sewing jig, tighten screw 6
and screw the compressed air supply 5 back on.
● Select INPUT mode.
● Select the Program number selection
function and enter the program and parts pro-
gram numbers which correspond to the part set.
● Confirm by pressing Enter.
6
Enter
Fig. 9 - 12
1
3
2
4
5
6
7
To Next Page
Loading...
