Adjustment
13 - 33
13.06.02 Height of the pocket plate guide
Requirement
The lowered pocket plate must be parallel to the top edge of the table.
● Check the requirement using a metal ruler.
● Loosen screws 1 and 2.
● Adjust the height of the guide 3 with screw 4 (nut 5) according to the requirement.
● Turn the plunger (lock nut) of cylinder 6 until the guide 3 is parallel to the table top.
● Tighten screws 1 and 2.
1
4
5
6
Fig. 13 - 30
2
3
To Next Page
Loading...
