11 - 1
Input mode functions
11 Input mode functions
This chapter lists and describes the functions in the INPUT mode. In this mode you will find
functions for program management, language selection, machine settings and configuration
as well as for service and adjustment work. However, this chapter does not describe how to
create seam programs. For information on how to create seam programs please refer to the
relevant instruction manual.
11.01 Summary of the functions in the INPUT mode
INPUT mode
Automatic program station change
Program number selection / Station key programming
Program station B
Program station A
Frame up/down
Bobbin thread functions
2 - BOBBIN-THREAD PRESELECT
1 - RESET STITCH-COUNTER
Head functions
1 - STANDARD STITCH LENGTH
2 - MAXIMUM SPEED
3 - REDUCED SPEED
4 - DELAY ZIGZAG ON
5 - DELAY ZIGZAG OFF
6 - SEWING
1 - INTERMEDIATE STOP
2 - UNI-MATERIAL
3 - BASIC POSITION POCKET PLATE
4 - ALTERNATING FOLDING
5 - ALTERNATING LABELLING
6 - EDGE FOLDER CONFIGURATION
Folder functions
Parts program functions
1 - ROLLING DIRECTION STACKER
2 - SLOW ROLLING TIME STACKER
3 - FAST ROLLING TIME STACKER
5 - TIME FOR EDGE FOLDERS BACK
6 - TIME FOR POCKET PLATE UP
7 - FEED SPEED
8 - SEAM CORRECTION X
9 - SEAM CORRECTION Y
Input menu (see chapter 11.02 Summary of the functions in the input menu)
1 - PROGRAM MANAGEMENT
2 - CREATE / MODIFY PROGRAM
3 - COUNTER
4 - SWITCH FUNCTIONS
5 - TIMES
6 - SERVICE (see chapter 11.03 Summary of the service functions)
4 - TIME FOR STACK TRESTLE BACK
7 - CHANGE PART SET
To Next Page
Loading...
