Input mode functions
11 - 8
Folder functions
(number key 8)
Opens a menu for selecting various folder functions:
1 2
3
4 5 6 7 9 0
Enter
8
Esc
Clear
Fig. 11 - 12
<- - - - >
1 - INTERMEDIATE STOP: OFF
2 - UNI-MATERIAL : OFF
3 - BASIC POSITION POCKET PLATE: FRONT
4 - ALTERNATING FOLDING: OFF
5 - ALTERNATING LABELLING: OFF
INTERMEDIATE STOP
Switches a function on or off which causes the program to stop on completion of the
folding operation (e. g. for correction of the pocket position).
The seam program can be continued by pressing the double-start keys.
UNI-MATERIAL
Changes the foot switch functions for working uni-materials (see chapter 7.03 ).
BASIC POSITION POCKET PLATE
Determines the baisc position of the pocket plate.
ALTERNATING FOLDING
When this function is active, every second pocket is not folded.
ALTERNATING LABELLING
When this function is active, only every second pocket receives a label.
EDGE FOLDER CONFIGURATION
With this function enabled, different edge-folder configurations
can be assigned to program stations "A" and "B"
CHANGE PART SET
After the function has been selected, the part set may be changed.
1
2
3
4
6
5
1 2
3
4 5 6 7 9 0
Enter
8
Esc
Clear
<- - - - >
6 - EDGE FOLDER CONFIGURATION OFF
7 - CHANGE PART SET
Fig. 11 - 12a
7
To Next Page
Loading...
