Preparation
9 - 10
9.09.02 Determining the jig code
Ones place Bit 0 Bit 1 Bit 2 Bit 3
Tens place Bit 4 Bit 5 Bit 6 Bit 7
0 free free free free
1 magnet free free free
2 free magnet free free
3 magnet magnet free free
4 free free magnet free
5 magnet free magnet free
6 free magnet magnet free
7 magnet magnet magnet free
8 free free free magnet
9 magnet free free magnet
Bit assignment
Example: decimal number ( 3 5 ) is equal to the binary combination (
11 00 10 1 0 )
The jig code is entered in the sewing program as a number value (0-99).
The code is created on the jig as a binary number by arranging up to 8 magnets in a
particular way on carrier 1.
ONES PLACE ( 5 )
TENS PLACE ( 3 )
Fig. 9 - 11
1
Bit 0
Bit 1
Bit 2
Bit 3
Bit 4
Bit 5
Bit 6
Bit 7
To Next Page
Loading...
