Adjustment
13 - 24
13.05.21 Presser height
Requirement
1. When the take-up lever is at TDC, the needle point must not extend under the
presser 1
when the presser 1 is raised.
2. The presser 1 must be aligned laterally so that the sewing thread is blown out from
under the presser 1 when the sewing jig is moved into position.
3
4
1
1
1
2
● Screw on presser 1.
● Bring the take-up lever 2 to TDC.
● Move the presser bar 3 (screws 4) according to requirement 1 and/or turn according to
requirement 2.
Fig. 13 - 22
To Next Page
Loading...
