Adjustment
13 - 32
13.06 Adjusting the folding, feed and stacker devices
13.06.01 Aligning the sewing jig
Requirement
The lowered sewing jig must lie evenly and lightly on the table top at both the folding and
the sewing stations, and hold the workpiece securely.
● Loosen screws 1 on both sides of the machine.
● Align the sewing jig by turning screws 2 (nuts 3) on both sides of the machine so that it
is parallel to the table top in the x-direction.
● Tighten screws 1.
● Align the sewing jig by moving the carrier 4 (screws 5 on both sides of the machine) so
that it is parallel to the table top in the y-direction.
1
2
3
5
4
x
x
y
y
Fig. 13 - 29
To Next Page
Loading...
