Pfaff 3588-04/020 - Zero Point Adjustment

8 - 5
Mounting and commissioning the machine
8.07 Adjusting zero point
It is necessary to adjust the zero point when the machine is commissioned and
after replacing the Controller or one of the proximity switches of the sewing jig
transport.
● Select INPUT mode.
● Select Input menu function (number key 0).
● Select the SERVICE function.
● Select the ADJUST ZERO POINT function.
● Enter the code number via the number keys.
The four-digit code number (factory setting: 3588) can be altered via the menu
functions. Please see chapter 11.03 Summary of the service functions and
11.05 Functions in the INPUT mode.)
Gauge position
● Select the GAUGE POSITION function.
● Press the plus key to position the sewing jig transport in the gauge position.
5
6
1
● Check if adjustment pin 1 can be inserted in the holes of the sewing jig and table when
the sewing jig is in this position.
Fig. 8 - 07
1