14 - 10
Controller
14.02.02 Errors - Sewing drive
If an error occurs during an operation with the sewing motor, the operation is canceled and
an error message is displayed.
The error message is generated by the motor controller and appears on the display of the
control panel; the index number is hexadecimal.
Number Error
1 Transfer error
2 Timeout serial interface
3 Check sum error in received data
4 Timeout command
30h Timeout slave expired (command string incomplete)
31h Incorrect command code
32h Framing or parity error
33h Check sum incorrect
34h Incorrect date on requests
35h No parameters programmable (motor is in operation)
36h Parameter does not exist
37h Incorrect parameter value
38h EEPROM is being programmed
39h Incorrect machine speed
3Ah Incorrect position
3Bh Path for guided positioning too short
3Ch Reset of the position counter not possible (motor is in operation)
3Dh Rotating in TDC after power-on not permissible
3Eh Synchronization marker not detected
3Fh Target position <3 incr. away from count position
40h - 4Fh -
50h Power monitoring (failure of 2 power half waves)
51h Malfunction power electronics on initializing
52h Short-circuit in the motor
53h Power off detected
54h Malfunction power electronics when in operation
55h No increments
56h Motor blocks
57h Commutating signal generator plug missing
58h Increment signal generator plug missing
59h Motor not running properly (set speed not achieved)
5Ah -
5Bh Feedback control algorithm is inhibited
5Ch - 69h -
6Ah EEPROM not programmable
6Bh EEPROM missing
6Ch Master Reset carried out
6Dh -
6Eh Remaining path for path-monitored, guided delay ramp too small
6Fh Slave has received 5 garbled messages in a row
70h Time monitoring system expired
71h - FFh -
To Next Page
Loading...
