Pfaff 3588-04/020 - Positioning the Edge Folding Unit

Adjustment
13 - 39
13.06.07 Positioning the edge folding unit
Requirement
When the edge folding unit and pocket plate are lowered
1. Folder arm 4 must be parallel with pocket plate arm 3 and the table top.
2. The pins in folder arm 4 and the bushes 2 in pocket plate gauge 1 must be aligned, and
3. there must be a clearance of 19 mm between folder arm 4 and pocket plate gauge.
4. The folder arm must rest lightly on the table top and hold the workpiece securely.
3
4
Fig. 13 - 35
2
1
4
19 mm
● Remove pocket plate and edge folder
● Insert pocket plate gauge 1 and bushes 2.
● Call up the SEWING mode.
● Switch on the manual sewing function (number key 0).
● Press the double start buttons.
● Operate the cycle forwards function until pocket plate arm 3 and folder arm 4 are
lowered.