9 - 7
Preparation
9.07 Automatic change in program station
If you want to change back and forth between two seam programs, a program
must be stored in each of both program stations (see chapter 9.06 Selecting a
seam program).
● Select the INPUT mode by pressing the respective key.
Depending on the setting and configuration of the machine the displayed status
bar may differ from the following example.
Fig. 9 - 08
● Activate the Automatic change in program station function (number key
4).
● Select the program station with which you would like to start (number keys 1 or 2).
1 2
3
4 5 6 7 9 0
Enter
8
Esc
Clear
or
To Next Page
Loading...
