Preparation
9 - 12
9.11 Loading of the cuttings
● Select the SEWING
mode.
● Select the Basic position
function.
● Lay the cutting for the trousers on the table and align it.
Loading and alignment of the pocket cuttings depends on the menu
combination selected (see chapter 7.03 ).
Menu combination: BASIC POSITION POCKET PLATE FRONT/PLAIN-MATERIAL
FABRIC ON
● Slide the pocket cutting onto the pocket plate according to Fig. 9-12.
Menu combination: BASIC POSITION POCKET PLATE BACK/PLAIN-FABRIC ON
● Actuate the loading function switch twice pocket plate moves forward.
● Slide the pocket cutting onto the pocket plate according to Fig. 9-12.
Menu combination: BASIC POSITION POCKET PLATE FRONT/PLAIN-MATERIAL OFF
● Slide the pocket cutting onto the pocket plate according to Fig. 9-12.
● Activate the inserting function switch - the pocket plate is lowered.
● Activate the inserting function switch to raise the pocket plate so that the trousers
cutting can be aligned.
● Activate the inserting function switch to lower the pocket plate again.
Menu combination: BASIC POSITION POCKET PLATE BACK/PLAIN-MATERIAL OFF
● Actuate the loading function switch to move the pocket plate forward.
● Slide the pocket cutting onto the pocket plate according to Fig. 9-12.
● Actuate the loading function switch twice: the pocket plate is lowered and raised slightly
to allow positioning of the trouser cutting.
● Actuate the loading function switch: the pocket plate is lowered and raised slightly to
allow positioning of the trouser cutting.
Fig. 9 - 12
Fig. 9 - 13
To Next Page
Loading...
