Adjustment
13 - 25
13.05.22 Bobbin winder
Requirement
1. When the bobbin winder is switched on, the bobbin winder spindle must move
securely with the winder.
2. When the bobbin winder is switched off, friction wheel 5 must not be driven by drive
wheel 1.
3. The bobbin winder must switch off automatically when the bobbin has been filled
approx. 1 mm from the edge.
● Move drive wheel 1 (screws 2) according to requirements 1
and
2.
● Move pin 3 (screw 4) according to requirement 3.
Fig. 13 - 23
1
2
5
3
4
1 mm
To Next Page
Loading...
