Pfaff 3588-04/020 - Position of Folder Plates

Adjustment
13 - 43
13.06.10 Position of folder plates
Requirement
1. The front edges of the folder plates 1 must be parallel to the die 4.
2. In the initial position, the folder plates 1 must be positioned on all sides approx.
0.1 mm under the lower edges of the strips of the die 4.
Fig. 13 - 38
4
1
1
3
3
3
3
2
2
2
2
0.1 mm
1
● Remove the folder.
● Align folder plate 1 (screws 2) according to requirement 1.
● Insert the folder plates 1 one after another according to the control sequence (see
chapter 13.06.09 Control sequence of the folder plates) and align according to
requirement 2 (screws 3).
● Remount the folder.