Input mode functions
11 - 2
11.02 Summary of the functions in the input menu
INPUT mode
Input menu
1 - PROGRAM MANAGEMENT
2 - CREATE / MODIFY PROGRAM (see chapter 11.06 Creating / modifying seam programs)
3 - COUNTER
4 - SWITCH FUNCTIONS
6 - SERVICE (see chapter 11.03 Summary of the service functions)
5 - TIMES
1 - DIRECTORY
2 - READ / WRITE PROGRAM
3 - DELETE PROGRAM
4 - FORMAT DISK
5 - STATISTICAL PROGRAM DATA
6 - DATA TRANSFER WITH PC
1 - RESET PIECE-COUNTER
2 - THREAD MONITOR
3 - SLOW START-STITCHES
4 - CARRIAGE START (NIS)
5 - START FOR THREAD TRIMMING
1 - THREAD MONITOR
2 - LANGUAGE SELECTION
3 - OPTIONS
5 - LOCK / RELEASE FUNCTIONS
4 - CONTINUOUS CARRIAGE MOVEMENT
2 - DIRECTORY OF DISK
1 - DIRECTORY OF MEMORY
1 - READ ONE PROGRAM FROM DISK
2 - READ ALL PROGRAMS FROM DISK
3 - WRITE ONE PROGRAM ON DISK
4 - WRITE ALL PROGRAMS ON DISK
1 - DELETE ONE PROGRAM IN MEMORY
2 - DELETE ALL PROGRAMS IN MEMORY
3 - DELETE ONE PROGRAM ON DISK
4 - DELETE ALL PROGRAMS ON DISK
1 - SURPR.ST. NEEDLE THREAD MON.
3 - STITCH REVERSAL
4 – RESPONSE TIME, NEEDLE THR. MONITOR
2 - SURPR.ST. BOBBIN THREAD MON.
1 - NEEDLE THREAD MONITOR
2 - BOBBIN THREAD MONITOR
3 - BOBBIN THREAD SENSOR
1 - GERMAN
3 - FRENCH
2 - ENGLISH
4 - SPANISH
5 - ITALIAN
1 - TILT HEAD
3 - FOLDER VERSION
2 - JIG MONITOR
4 - LABEL FEED
5 - JIG VERSION
1 - TIME FOR LABEL CLAMP CLOSED
6 - POLISH
To Next Page
Loading...
