14 - 15
Controller
14.02.06 Errors - Stitch generation
If an error occurs during the calculation of the stitch data, the operation is canceled and an
error message will be displayed. The error message appears in clear text and possibly with a
number in brackets. This number indicates the section where the error occurred.
Additionally, errors may occur which have not been assigned a special text. Please refer to
the following table for the meaning of the error number.
Number Error
0 No Error
1 Wrong machine code in geometrical data record
2 Section clamp or section obstacle is missing or at the wrong place
3 Increment too large
4 Program end without trimming
5 Stitch length inadmissible
6 Wrong element in the geometrical data record
7 Fast slew although machine is sewing
8 Stitch length inadmissible (line)
9 Stitch length inadmissible (circle)
10 Circle point = circle end point
11 Division by 0
12 Stitch length inadmissible (curve)
13 No coordinate section in front of the curve point
14 Sewing area exceeded
15 Curve without end point
16 Machine functions buffer full
17 Start sewing command in the loading position program
18 Wrong curve point
19 Wrong curve point
20 Wrong curve point
21 Wrong curve point
22 Stitch length not initialized
23 Loading position program not finished
24 Stitch width command in the loading position program
25 Value not permissible for section stitch direction
26 Trimming command although thread has been trimmed
27 Start sewing command, although machine is sewing
28 Trimming command in the Sewing-Off area
29 Sewing-Off command, although thread has been trimmed
30 Trimming command immediately after Start Sewing command
To Next Page
Loading...
