9 - 9
Preparation
9.09 Jig monitor (optional)
To make it possible to monitor the jig, the sewing jig is given a code using magnets which
the control can recognize via an additional device. This is a means of preventing pairing a
sewing program with the wrong sewing jig which could cause the needle to break.
If the machine is equipped with this optional device, the JIG MONITOR function must be
activated, and a jig code must be entered in the sewing program in order to use the jig
monitor.
9.09.01 Activating jig monitor
● Select the INPUT mode by pressing the respective key.
Depending on the setting and configuration of the machine the displayed status
bar may differ from the following example.
Fig. 9 - 10
● Select the Input menu
function (number key 0).
● Select the SWITCH FUNCTIONS function.
● Select the OPTIONS function.
● Select the JIG MONITOR function.
● Activate or deactivate the function by pressing the number keys 1
or 0 respectively.
1 2
3
4 5 6 7 9 0
Enter
8
Esc
Clear
4
3
2
0
1
or
To Next Page
Loading...
