11 - 3
Input mode functions
11.03 Summary of the service functions
Input menu
6 - SERVICE
INPUT mode
2 - THREAD TRIMMING PROCEDURE
1 - TURN SEWING MOTOR1 - SEWING DRIVE FUNCTIONS
3 - CUTTING SPEED - PRE-SEL.
2 - STEPPING MOTOR 2
3 - MOVE CARRIAGE
4 - TEST CARRIAGE
2 -STEPPING MOTOR FUNCTIONS 1 - STEPPING MOTOR 1
3 - SWITCH OUTPUTS
4 - DISPLAY INPUTS / OUTPUTS
5 - ADJUST ZERO POINT 1 - GAUGE POSITION
2 - NEEDLE POSITION
3 - FOLDER POSITION
6 - CONFIGURE MACHINE
1 - TILTABLE HEAD
2 - VERTICAL HOOK
3 - JIG MONITOR
4 - LABEL FEED
5 - HEIGHT ADJUSTMENT
7 - OTHER FUNCTIONS
1 - WRITE MACHINE DATA ON DISK
2 - READ MACHINE DATA FROM DISK
3 - CARRY OUT COLD START
4 - DISPLAY SOFTWARE STATUS
5 - CONTRAST SETTING OF DISPLAY
6 - CHANGE CODE NUMBER
For an explanation of the service functions please refer to chapter 11.05
Functions in the Input mode, page 11-16 ff.
To Next Page
Loading...
