Pfaff 3588-04/020 - Explanation of the Functions in the Initial State (When Entering Seam Programs)

11 - 23
Input mode functions
11.06.04 Explanation of the functions in the initial state (when entering seam
programs)
Fig. 11 - 36
1 2
3
4 5 6 7 9 0
Enter
8
Esc
Clear
X: 2500 Y: 0 1 : PROGRAM NUMBER
# 500
Step-by-step forwards (number key 1)
This function allows you to trace the seam pattern step by step in a forward direction; by
pressing Enter simultaneously, the entire seam pattern is traced automatically.
Step-by-step backwards (number key 2)
This function allows you to trace the seam pattern step by step backwards; by pressing
Enter simultaneously, the entire seam pattern is traced automatically.
Presser foot up / down (number key 3)
Allows you to raise and lower the presser foot.
Block functions (number key 4)
1 2
3
4 5 6 7 9 0
Enter
8
Esc
Clear
Fig. 11 - 37
1 - MARK START OF BLOCK
2 - MARK END OF BLOCK
3 - MANIPULATE BLOCK .....
4 - MOVE BLOCK
5 - DELETE BLOCK
MARK START OF BLOCK/MARK END OF BLOCK
After a desired point in the program has been selected by tracing the seam pattern, the
function MARK START OF BLOCK allows you to determine the start of a block.
Marking the block must be completed by determining the end of the block. To do so,
trace the pattern to the desired point and select the function
MARK END OF BLOCK. When tracing the seam pattern, the marked block can be
identified since the section number and type are displayed on a dark background.
MANIPULATE BLOCK
This function comprises the sub-functions SCALE UP FACTOR FOR X-AXIS, SCALE UP
FACTOR FOR Y-AXIS, ROTATION ANGLE and MIRROR. The functions can be
performed separately or at the same time (see Fig. 11-38).
If the ROTATION ANGLE and MIRROR functions are to be performed simultaneously,
the block is first mirrored and then rotated.
1
2
3