Input mode functions
11 - 24
1 2
3
4 5 6 7 9 0
Enter
8
Esc
Clear
Fig. 11 - 38
1 - SCALE UP FACTOR FOR X-AXIS: 1.00
2 - SCALE UP FACTOR FOR Y-AXIS: 1.00
3 - ROTATION ANGLE 0°
4 - MIRROR OFF
SCALE UP FACTOR FOR X-AXIS
Enlarges a block.
SCALE UP FACTOR FOR Y-AXIS
Reduces a block in size.
ROTATION ANGLE
Rotates a block.
The block is rotated anti-clockwise around the start-of-block point.
MIRROR
Mirrors a block. The block is mirrored around a straight line which runs through the
start-of-block point and is parallel to the y-axis.
MOVE BLOCK
After the MOVE BLOCK function has been selected, the sewing jig feed device has to
locate in a new spot. Press
Enter Enter
Enter Enter
Enter to confirm the new position and move the block.
DELETE BLOCK
Deletes a block.
Pattern functions
(number key 5)
1
2
3
4
4
5
1 2
3
4 5 6 7 9 0
Enter
8
Esc
Clear
Fig. 11 - 39
1 - MOVE PATTERN
2 - MANIPULATE PATTERN .....
(SYMMETRY POINT WITH TRANSFER KEYS)
3 - MANIPULATE PATTERN .....
(SYMMETRY POINT WITH NUMERIC KEYS)
MOVE PATTERN
After the MOVE PATTERN function has been selected, the sewing jig feed device has
to locate in a new spot. Press Enter
to confirm the new position. The pattern is then
moved from the current position to the end of the program.
MANIPULATE PATTERN
(SYMMETRY POINT WITH TRANSFER KEYS)
The symmetry point is located (entered) by pressing the transfer keys.
MANIPULATE PATTERN
(SYMMETRY POINT WITH NUMERIC KEYS)
The symmetry point is determined by entering the coordinates via the numeric keys.
After the symmetry point has been entered, the functions SCALE UP FACTOR FOR X-
AXIS, SCALE UP FACTOR FOR Y-AXIS, ROTATION ANGLE and MIRROR are available.
For a description of the function please refer to page 11-21 MANIPULATE BLOCK. All
functions are applied to the entire program.
1
3
2
To Next Page
Loading...
