Adjustment
13 - 5
13.05.03 Upper and lower toothed belt guards
Requirement
The upper and lower toothed belt guards must be positioned as close as possible over
the toothed belt sprockets without touching them.
● Move the upper 1 (screw 2) and lower toothed belt guards 3 (screws 4) at the underside
of the sewing head according to the requirement.
Carry out the adjustment carefully!
Otherwise, when the sewing head is raised up, the toothed belt could
disengage!
1
Fig. 13 - 04
3
4
2
1
To Next Page
Loading...
