Adjustment
13 - 37
13.06.05 Front pocket plate position
Requirement
When the folder is positioned at zero point, the adjustment holes of the pocket plate and
the sewing jig must be aligned.
● Switch on the machine.
● Select the INPUT mode.
● Select the FOLDER POSITION function from the service menu (see chapter 11.03
Summary of the service functions).
● Set the value for the y-axis to "0".
● Check the requirement using the adjustment pin 1.
● Change the value for the x-axis according to the requirement via the control panel and
store.
● Move the pocket plate arm 2 (screws 3) according to the requirement.
The machine remains switched on for further adjustments.
Fig. 13 - 33
1
2
3
To Next Page
Loading...
